Welcome to the first official day of the Mirrix Tapestry and Bead Looms Weave-Along. If you are a participant, we look forward to getting to know you and your work! If you are just observing, enjoy! We hope everyone will learn a lot from this experience.
This is a basic outline of this weave-along:
|Loom with warping bar between the two clips.|
|My loom, just as I finished putting the warp on.|
|The top of the loom, fifteen warps across.|
|Loom with warp on it. The cord on the right side helps balance the warping bar (which has been pulled down lower on the loom).|
|Looking down at the warping bar towards the bottom of the loom.|
After putting heddles on every other warp, I rotated the warping bar and began to put heddles on the warps that did not already have heddles on them.
|The shedding device, rotated and ready for more heddles on the other side.|
|The loom, warped and with heddles on both sides of the shedding device. I'm almost done!|
|Close-up of the heddles on the loom.|
|The loom, ready to be woven on with the shedding device handle attached.|
|C-Lon cord to be used for my header.|
|My header, woven.|
|All set to weave the cuff!!!|
Please, post pictures this week of your loom warped and ask questions on this blog (as a comment),